Worx LANDROID M Guia De Instalacion página 8

2
Press and hold down the
Power ON/OFF key until
the Landroid M turns on.
®
Open the control panel cover,
press the key and close
the control panel cover: your
Landroid M will now
®
find its way to the charging base.
Watch the Landroid M as
®
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Landroid M successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid M will
®
start to fully charge.
NOTE: If your Landroid M is in the charging base during a time you have programmed it to mow, press STOP then simply
®
14
press the Start button to proceed with mowing.
EN
• If your Landroid M • If your Landroid
®
is outside its territory, inside its territory but
it will not move and the display says "out of
Warning
the display will indicate cutting area" and the
"out of cutting area" LED is on, it means you
error. Just move it inside clamped the boundary
its territory and repeat wire ends incorrectly.
step 2. Just reverse them.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
M is • Your Landroid M should • Should your
® ®
always remain switched Landroid M stop
®
on. If you ever need to operating unexpectedly,
turn it off, then make sure just press its ON/OFF
you place it within its key to ON, correct the
boundary area before you problems, press Start
switching it back on again. button.
Programming
Having finished the installation, it is now time to program the Landroid
display shown below. Please refer to the Programming and Troubleshooting Guide included in the packaging.
Ready to go?
The Landroid ® M is designed for maintaining your grass at a perfect length during the season, but is not designed for deforesting a jungle.
Before starting it for the first time,
1. You should mow your lawn to the desired height.
2. Make sure the operating area is clear from objects such as toys and branches...
3. Adjust the cutting height to its maximum level for the first mow and then adjust to your preferred lawn grass height.
Next Spring, let your Landroid M start mowing early, when the grass is still short, so that you can avoid a preliminary grass cut.
®
M when you want it to go to work by using the keypad
®
09:00pm
Wed. 6-8-2012
M T W T F S S
7:00am ~ 12:00am
15
EN