"Pair" To Your Bluetooth Phone; Basic Operations; Turning Headset On/Off - Jabra FreeSpeak 250 Manual Del Usuario

4

"Pair" to your Bluetooth phone

Pairing 3 will create a unique and encrypted wireless link between two Bluetooth-
enabled devices such as your Bluetooth phone and JABRA FreeSpeak 250.
1. Ensure the headset is off (see Turning
headset on/off section).
2. Press and hold until you see a solid
blue light (approximately 8 seconds),
then release* (see Fig. 2).
3. Set your Bluetooth phone to "discover"
the headset by following your phone's
instruction guide. Typically, the steps
involve going to a "setup" , "connect" , or
"Bluetooth" menu on your phone and
then selecting the option to "discover" a
Bluetooth device.
4. Your phone will find the "JABRA 250"
headset and ask if you want to pair with
it. Confirm this by pressing "yes" or "ok" .
5. Enter passkey or PIN 4 = 0000 (4 zeros),
then press "yes" or "ok" .
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions. Phone-
specific pairing instructions can be found online at www.jabra.com/fscs
6

BASIC OPERATIONS

5

Turning headset on/off

What you do
Turning Press and hold
headset on seconds until you see a
burst of flashes on the blue
indicator light, then release
Turning
Press and hold
Fig. 2
headset off
seconds until you see a
burst of flashes on the blue
indicator light, then release
Status indicators
What you see
Flashes every
second
Fig. 3
Flashes every
3 seconds
3 flashes every
second
3 flashes every 3
seconds
* Depending on phone type and usage.
IMPORTANT: Do not hold the
turning the headset on or else it may go into pairing mode, and the blue indicator light
will turn solid. If that happens, turn off the headset, wait 3 to 5 seconds, and repeat
process for turning the headset on.
What you hear
for 3 to 5 Ascending
(low-to-high)
tones
for 3 to 5 Descending
(high-to-low)
tones
What you hear Status
Quick series of 2 tones – Active Mode
•
low to high pitch (when Call in progress
•
active mode starts) Up to 8 hours of talk-time*
Quick series of 2 tones – Standby Mode
•
high to low pitch (when Waiting for call
•
standby mode starts) Up to 240 hours of
standby time*
3 beeps every 30 seconds Low Battery (in active mode)
•
3 – 5 minutes of talk time left
3 beeps every 5 minutes Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
button down for more than 3 to 5 seconds when
What you see
The blue indicator
light will flash while
the power is on (see
Status indicators
table below)
The blue indicator
light will stop
flashing
5
6
7