Beninca ONE.4WB Manual Del Usario página 11

MENU
If selecting the menu Radio the screen shows "PSU", it means that the memory has been protected by a Password using
the programmer ADVANTOUCH. Every operation on the receiver memory can be done only with the ADVANTOUCH.
Menu to type in the transmitter codes in memory. The message FULL means that the receiver
memory is complete. The submenus are described hereunder:
ch1
ch2
ch3
ch4
Add
SInc
FIX
SER
Menu to erase previously typed in transmitter codes from memory.
The single submenus are described hereunder:
code
del
indh
recn
Clears completely the receiver memory deleting all the transmitters, their associations, the
res
encoding type settings and the parameters of the channels. It is necessary to confirm this
operation before to proceed.
3.3) RADIO
The key is associated to channel 1. Press, within 5 sec, the transmitter key which
is to be associated to channel 1.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 2. Press, within 5 sec, the transmitter key which
is to be associated to channel 2.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 3. Press, within 5 sec, the transmitter key which
is to be associated to channel 3.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 4. Press, within 5 sec, the transmitter key which
is to be associated to channel 4.
Synchronism control is activated (see Synchronism paragraph).
The four keys of a four channel transmitter are automatically associated, each
one to the corresponding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is activated (see Synchronism paragraph).
The four keys of a four channel transmitter are automatically associated, each
one to the corresponding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is not activated (see Synchronism paragraph).
Serialised remote controls are typed in.
Packages of factory serialised remote controls, i.e. transmitters with consecutive
codes. First of all press any key on the transmitter with lower serial code, then
any key on the transmitter with higher serial code. All transmitter codes which
are within these two codes will be automatically stored in memory. Associations
are automatically carried out (key1:ch1, key2:ch2, etc)
Synchronism control is activated (see Synchronism paragraph).
The receiver is in a waiting mode, waiting for a memorized transmitter key to
be pressed.
The transmitter is erased from the receiver memory.
Remove a control unit code for which the position in memory is know, see fun-
ction Find>Code
Remove a control unit code for which the position in memory is know, see fun-
ction Find>Code.
Unlike the function InDh which scrolls through all the positions of the memory, the
menu rEcn scrolls only through the positions occupied by a transmitter.
FUNCTION
11