Beninca ONE.4WB Manual Del Usario página 9

1) SPECIFICATIONS
- Four output, independent and freely configurable channels
- 433,92 MHz receiver configurable as rolling code HCS/advanced rolling code (ARC)/ fixed code.
- Programming through built-in LCD display
- Programming through ADVANTOUCH programmer and corresponding software for PC Windows (optional).
Input No. Function
L-N Power supply
CH1 Channel 1
CH2 Channel 2
CH3 Channel 3
CH4 Channel 4
COM-IN1-IN2 Input 1 and 2
ANT-SHIELD Antenna
Connector
ADV
ADVANTOUCH
Note:
The U6 memory can contain 512 rolling-code HCS or ARC, 433.92MHz, transmitters maximum. If necessary, it can
be replaced with item MEM2048 which can contain up to 2048 different codes.
2) ARC (ADVANCED ROLLING CODE)
The radio receiver ONE4.WB is compatible with the new ARC (Advanced Rolling Code) transmitters which, thanks
to 128-bit encryption ensure superior copy-security.
Storing new ARC transmitters is quite similar to that of normal rolling code transmitters with HCS coding, but be
aware that:
1) Transmitters of different encoding type cannot be stored in the same ONE.4WB.
2) The first transmitter stored in memory defines the type of transmitters to be used afterwards. For example if the
first transmitter is ARC it will not be possible to store in memory rolling code (HCS ) transmitters or fixed code ones
and vice versa.
3) If you want to change the type of transmitters it is necessary to proceed with a receiver reset (Menu Radio>Reset).
When the receiver is switched on or by pressing the buttons (+) and (-) simultaneously the screen shows the type
of transmitters in use according to the following diagram:
RC rolling code HCS
ARC advanced rolling code
Fix fixed code
- - - no transmitters in memory/ no encoding type set
ONE.4WB
1.1) IN/OUT FUNCTIONS
Description
Power supply 90-255 Vac 50/60 Hz
Output, channel 1. 250 Vac max 5A.
Normally Open (N.O.) Contact, switchable in Normally Closed (N.C.)
through jumper 1.
Output, channel 2. 250 Vac max 5A.
N.O. Contact, switchable in N.C. through jumper 2.
Output, channel 3. 250 Vac max 5A.
N.O. Contact switchable in N.C. through jumper 3.
Output, channel 4. 250 Vac max 5A.
N.O. Contact, switchable in N.C. through jumper 4.
Inputs configurable by means of the parameter and logic menu, they
can activate one of the channel CH1/CH2/CH3/CH4 in the same way of
a remote control.
Antenna connection of the built-in radio module
(11-screen/12-signal).
Input for ADVANTOUCH (C4 Cable).
The receiver memory can be managed through the ADVANTOUCH
software and the relevant programmer.
For further information, please refer to ADVANTOUCH instructions
9