Beninca ONE.4WB Manual Del Usario página 12

Search Menu for transmitter codes stored in memory.
The single submenus are described hereunder:
find
code
n tx
It allows to type in an access protection code to the programming of the control unit.
A four-character alphanumeric code can be typed in by using the numbers from 0 to 9 and the letters A-B-C-D-E-F.
The default value is 0000 (four zeros) and shows the absence of a protection code.
While typing in the code, this operation can be cancelled at any moment by pressing keys + and – simultaneously.
Once the password is typed in, it is possible to act on the control unit by entering and exiting the programming
mode for around 10 minutes in order to allow adjustments and tests on functions.
By replacing the 0000 code with any other code, the protection of the control unit is enabled, thus preventing
the access to any other menu. If a protection code is to be typed in, proceed as follows:
- select the Code menu and press OK.
- the code 0000 is shown, also in the case a protection code has been previously typed in.
- the value of the flashing character can be changed with keys + and -.
- press OK to confirm the flashing character, then confirm the following one.
- after typing in the 4 characters, a confirmation message "CONF" appears.
- after a few seconds, the code 0000 appears again
- the previously stored protection code must be reconfirmed in order to avoid any accidental typing in.
If the code corresponds to the previous one, a confirmation message "OK" appears.
The control unit automatically exits the programming phase. To gain access to the Menus again, the stored
protection code must be typed in.
IMPORTANT: TAKE NOTE of the protection code and KEEP IT IN A SAFE PLACE for future maintenance operations.
To remove a code from a protected control unit it is necessary to enter into programming with the pas-
sword and bring the code back to the 0000 default value.
IF YOU LOOSE THE CODE, PLEASE CONTACT THE AUTHORISED SERVICE CENTER FOR THE TOTAL
RESET OF THE CONTROL UNIT.
4) SYNCHRONISM
According to the typing in mode, the synchronism control may be activated or deactivated.
Transmitters with activated synchronism control
This is the default mode which allows synchronism between transmitter and receiver, thus ensuring the safety offered
by the rolling-code system/Advanced Rolling Code.
Transmitters with deactivated synchronism control
In this mode, the synchronism function is disabled and the transmitter code can be copied. Hence, by using the
ADVANTOUCH system, a virtually infinite number of transmitter codes identical to the original can be created.
12
The receiver will wait to receive a code, press a button on the transmitter, if
present, see the location in memory.
The number of transmitter codes stored in the receiver memory is displayed.
3.4) PASSWORD (pass)