Operating The Hedge Trimmer - Worx WG250 Manual Del Usuario

ply and the green light (13) will illuminate
Then, fully insert the battery pack into the char-
ger to make the connection and the red light
(14) will illuminate to show charging has start-
ed . A discharged battery at normal ambient
temperature will take approximately 1 hour to
reach full charge. Charging time may vary due
to variable ambient temperatures and battery
conditions. When charging is completed the
green light (13) will illuminate to indicate end of
charge (See D) .
Note: green = power on,
red = charging,
Battery pack inserted + green light =
charging completed
The battery pack can then be removed for use
in your hedge trimmer.
The charger timer circuit and battery pack tem-
perature safety cut-out device prevent
overcharging of your battery pack.
Warning: After long usage the battery will be-
come hot, let the hot battery cool down for 1
hour before recharging.
5. TO REMOVE OR INSTALL BATTERY
PACK
Release the handle and rotate to the position
in (figE). Locate latches on side of battery pack
10
and depress both sides to release battery pack
from your hedge trimmer. Remove battery pack
from your hedge trimmer. After recharging in-
sert the battery pack into hedge trimmer's bat-
tery port. A simple push and slight pressure will
be sufficient. Check to see if the battery is fully
secured.
STARTING AND STOPPING
BEFORE STARTING
TRIMMER
Remove blade sheath (10) (See F).
TO START YOUR HEDGE TRIMMER
Your trimmer is equipped with two switch
levers (2 & 4). Both switch levers need to be
pressed for the hedge trimmer to start. Depress
and hold the front switch lever (4) and press the
rear switch lever (2) (See G).
TO STOP YOUR HEDGE TRIMMER
Move hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See H).
Cordless Hedge trimmer
CTC-WG250-M-060417.indd 10
.
your hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury.
DO NOT USE WITHOUT HANDLE AND
GUARD.
OPERATING THE HEDGE
TRIMMER
ADJUSTING
POSITION
The front handle can be set in three
positions.
Lever(6) to adjust the front handle to the
most comfortable position. Then close
CAM Lever(6) to lock it in that position
(See I) Caution: Ensure you support the
weight of the hedge trimmer before you
adjust the front handle.
HOW TO USE YOUR HEDGE TRIMMER
Note that the switch lever can be activated
on three sides, giving you many choices for
a comfortable grip. Before cutting an area,
inspect it first and remove any foreign objects
that could become thrown or entangled in the
blades. Always hold the trimmer with both
hands and with the blade away from you before
turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade (See J & K).
Allow the cutting blades to reach full speed
YOUR HEDGE
before cutting.
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two switch levels (2 & 4)
before attempting to clear jammed debris from
the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
Warning: If any parts are missing,
damaged or broken, do not operate
THE FRONT
Release the
When operating, keep the
HANDLE
Handle CAM
ENG
2006-4-20 14:53:30