Pioneer SE-C4BT Manual De Instrucciones página 19

7. Vocal communication
To use the wireless headphones for vocal communication, pairing must be per-
formed with the desired Bluetooth device using the "hands-free profile" (HFP).
For details on how to perform pairing, see P.5.
(1) With power to the wireless headphones' turned off, hold the Power but-
ton depressed for about three seconds.
The headphones' power will turn on and the LED indicator will flash blue.
(2) Turn on the Bluetooth function on the device you wish to connect to.
When pairing is completed, the wireless headphones will automatically connect
to the Bluetooth device.
* If automatic connection is not achieved, or the headphones automatically connect
to a different Bluetooth device than the one you wish to use, follow the instructions
for the desired Bluetooth device regarding manual connection.
Vocal communication controls
If the connected Bluetooth device supports AVRCP, the following operations can be
used.
• ( + ) button
Press once : Increase volume.
• ( – ) button
Press once : Decrease volume.
• Power button
Press once when receiving a message : Enables conversation.
Press once again to end conversation.
Press and hold when receiving a message : Refuse communication.
Press twice : Performs redialing.
The same controls are supported in the event a call is received while listening to
music.
* When sound volume is set to maximum or minimum levels a beep sound will be
produced from the headphones.
* Sound volume can be adjusted on the matching Bluetooth device.
* Depending on the specifications of the connected Bluetooth device, the controls
noted above and controls on the Bluetooth device may not be supported.
* Depending on the specifications of the connected Bluetooth device, the phone
settings may need to be configured. Consult the user's manual for the Bluetooth
device.
7
En