Troubleshooting - Troy-Bilt 200 Serie Manual Del Operador

Troubleshooting

Problem
Engine fails to start
Engine runs erratic
Engine overheats
Tines do not engage
10
Cause
1. Spark plug wire disconnected.
2. Fuel tank empty or stale fuel.
3. Throttle control lever (if equipped) not in correct
starting position.
4. Choke not in ON position.
5. Blocked fuel line.
6. Faulty spark plug.
7. Engine flooding.
1. Spark plug wire loose.
2. Unit running on CHOKE.
3. Blocked fuel line or stale fuel.
4. Vent plugged.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
7. Carburetor out of adjustment.
1. Engine oil level low.
2. Dirty air filter.
3. Air flow restricted.
4. Carburetor not adjusted properly.
1. Foreign object lodged in tines.
2. Tine clevis pin(s) missing.
3. Belt worn and/or stretched.
4. Pulley and idler not in correct adjustment.
Remedy
1. Connect wire to spark plug.
2. Fill tank with clean, fresh gasoline.
3. Move throttle lever to start position.
4. Move lever to ON position.
5. Clean fuel line.
6. Clean, adjust gap, or replace.
7. Wait a few minutes to restart, but do not prime
(if equipped).
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF.
3. Clean fuel line; fill tank with clean, fresh gasoline.
4. Clear vent.
5. Drain fuel tank. Refill with fresh fuel.
6. Clean following engine manual.
7. Refer to engine owner's manual.
1. Fill crankcase with proper oil.
2. Clean air cleaner.
3. Remove blower housing and clean.
4. Refer to engine manual.
1. Stop tiller completely, check and discard foreign
object.
2. Replace tine clevis pin(s).
3. Replace belt.
4. Take unit to authorized service dealer.
6