Troy-Bilt 200 Serie Manual Del Operador página 6

5. Insert the Z-fitting on the clutch cable into the
hole on the tine clutch control. Hook the "Z"
end into the opening from the inside to the
outside as shown in Figure 3-6.
Z-fitting
Clutch Cable
Tine Clutch Control
Figure 3-6
6. Squeeze the tine clutch control inward. Insert the
right end into the hole on the right side of the
upper handle. See Figure 3-7.
Clutch Control
Figure 3-7
Wheels
Fo shipping reasons the wheels are shipped in the
reverse position. To install the wheels in the proper
position proceed as follows:
1. Remove the clevis pin and cotter pin from the
wheel assembly. See Figure 3-8.
Figure 3-8
6 S 3— A
ection SSembly
2. Slide the wheel assembly out of the bracket,
rotate the wheel assembly 180° and reinstall as
shown in Figure 3-9 using the clevis and cotter
pin to secure in place.
Depth Stake
For shipping reasons the depth stake is shipped
unnattached and can be found in the package with
the tine assemblies.
1. Remove the depth stake from the packaging,
and slide it into place on the rear opening of
the bracket. See Figure 3-10.
2. Select the desired height and secure the depth
stake in place with a clevis pin and cotter pin.
See Figure 3-10.
Cotter Pin
& S -U
et p
Figure 3-9
Clevis Pin
Figure 3-10
Adjustments
Wheels
The tiller is shipped with the wheel adjusted such
that the unit sits level. Before tilling, the wheel must
be raised. To do this, remove the clevis and cotter
pins, raise the wheel to the desired position, then
reattach pins to secure, Figure 3-11. For transporting
the tiller, reverse the steps to lower the wheel.
Cotter Pin
Figure 3-11
Set-Up
Gas & Oil Fill-Up
Service the engine with gasoline and oil as instructed
in the separate engine owner's manual packed with
your tiller. Read the instructions carefully.
WARNING! Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running.
Clevis Pin