Functions in Detail
• This is a general use remote controller, it could be used for the air conditioners with multifunction; For some
function, which the model doesn't have, if press the corresponding button on the remote controller that the
unit will keep the original running status.
• After putting through power, air conditioner will give out a sound and operation indicator is ON (red indica-
tor). You can operate the air conditioner through the remote controller.
• At ON status, after each pressing button on remote controller, the signal icon on remote controller will flash
once. Air conditioner will give out a sound,which indicates the signal has been sent to air conditioner.
• Under off status, set temperature and clock icon will be displayed on the display of remote controller (If
timer on, timer off and light functions are set, the corre-sponding icons will be displayed on the display of
remote controller at the same time); Under on status, the display will show the corresponding set function
icons.
Press this button, the unit will be turned on, press it once more, the unit will be turned off.
1
ON/OFF
When turning on or turning off the unit, the Timer, Sleep function will be canceled, but the
presetting time is still remained.
Press this button, Auto > Cool > Dry > Fan > Heat mode can be selected circularly. Auto
mode is default while power on. Under Auto mode, the temperature will not be displayed;
2
MODE
Under Heat mode, the initial value is 28°C (82°F); Under other modes, the initial value is
25°C (77°F).
Presetting temperature can be decreased. Press this button, the temperature can be set
up, continuously press this button and hold for two seconds, the relative contents can
3
[-]
quickly change, until unhold this button and send the orderthatthe °C (°F) signal will be
displayed all the time. The temperature adjustment is unavailable under the Auto mode,
but the order can be sent by if pressing this button.
For presetting temperature increasing. Press this button, can set up the temperature, when
unit is on. Continuously press and hold this button for more than 2 seconds, the corre-
sponding contents will be changed rapidly, until unpress the button then send the infor-
4
[+]
mation, °C (°F) is displlaying all along. In Auto mode, the temperature can not be set up,
but operate this button can send the signal. Centigrade setting range: 16-30; Fahrenheit
scale setting range 61-86.
Press this button, Auto, Low, Middle, High speed can be circularly selected: Auto > Low > Middle
5
FAN
> High. Under the Dry mode, the fan speed isn't adjustable, low fan speed is imperative,
Press this button to set up & down swing angle, which circularly
changes as right picture. This remote controller is universal. If any
signal is sent out, the unit will carry out the command as [
6
[
up and down, if turn off the Swing, the air guide louver will stop at current position.
Press CLOCK button, blinking [ ]. Within 5 seconds,pressing + or - button adjusts the pre-
sent time. Holding down either button above 2 seconds increases or decreases the time
by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During blinking
7
CLOCK
after setting, press CLOCK button again to confirm the setting, and then the symbol will be
constantly displayed. If the signal is displayed that means the current time value is Clock
value, otherwise is Timer value.
31
] indicates the guide louver swings as
] .
. When the guide louver start to swing