Operation - Fagor HTT 101 Manual De Instrucciones

3. Operation

HTT HOME is controlled and managed through the key board and LCD display.
LCD Display – It presents the selected menu and the parameter settings. The backlight in the
display is on when the power is applied.
LED – These lights indicate the working status

Power: It lights on when the power supply is connected.

Alarm: It lights on when there is error, such as the signal source loss.

Lock: It lights on when the signal source connected and goes off when the signal lose.
Left/Right/Up/Down buttons – Use these buttons to turn the screen pages, shift the target
items by moving the triangle, or change the parameter settings in the program mode.
Enter – Use this button to enter a submenu or save a new setting after adjustment; press it to
start adjusting the value of certain items when the corresponding underline flash with Up and
Down buttons;
Hue
Enter
1
Press it to activate the hidden selections and change the setting with Up and Down (or Left
and Right) buttons.
Audio Bit rate
Enter
128
Menu – Press this button to step back
Lock – Locking the screen / cancelling the lock state, and entering the main menu after the
initialization of the device. After pressing lock key, the system will question the users to save
present setting or not. If not, the LCD will display the current configuration state.
When the power is connected, the LCD will start to initialize the program. The LCD menu goes
as below chart.
Hue
►
+001
Audio Bit rate
Enter
*128
Hue
+001
Audio Bit rate
►128
Hue
+002
Audio Bit rate
►192