In order to work in the maximum safety conditions and to avoid any dangerous situation and accident, the operator
must follow the operating instructions and regulations listed below.
- If the machine must be disarmed immediately for any reason whatsoever, turn the main switch to the OFF position.
- During the machine functioning, it is strictly forbidden to remove the safety devices assembled by the builder on
the machine in order to protect the operator while performing his tasks.
- Only skilled and qualified operators can use the machine.
- Never leave the machine unattended.
- To work, the machine requires only one operator.
- It is obbligatory to wear protective gloves when using the machine.
- It is obbligatory to wear protective goggles when using the machine.
The following warning plates are applied to the machine:
- a warning label relative to the risk of electrocution;
- a warning label relative to the danger posed by moving parts;
- a warning label relative to the danger of the tank under pressure;
- a warning label relative to the danger of heat - steam emissions;
- a warning label prohibiting personnel from using water to put out fires on electrical equipment;
- a warning label prohibiting personnel from touching equipment under voltage;
- a warning label obligating the operator to check the efficiency of the safety protection measures before
starting up the machine;
- a warning label obligating the operator to consult the operating manual before using the machine.
USER'S INSTRUCTIONS
ADDITIONAL RISKS
WARNING ABOUT THE ADDITIONAL RISKS
12