Victron energy VE.Net Blue BPP2 Manual De Instrucciones página 30

Note: Only the options supported by the currently connected system will
be shown in the menu. In systems with multiple A.C. inputs/outputs,
some properties will appear multiple times.
Items marked with
properly registered.
Settings under the "VVC" menu are stored in the VVC, and not the target
device. This means that the value will be remembered if you connect a
different target (and conversely, if the VVC is replaced, these settings will
need to be re-configured).
Warning: An incorrectly configured device can cause damage to the
system. Before changing any options make sure you know the associated
risks. The descriptions below are summaries only; if in doubt consult the
manual for the target device, or your Victron dealer.
Name
Root menu
Device switch
Shore cur. limit
Device state
DC voltage
DC current
Mains AC voltage
Mains AC current
Mains AC power
Mains frequency
Inv. AC voltage
Inv. AC current
Inv. AC power
Inv. frequency
VVC version
24
require a panel restart before the changes will be
†
Table 6-1 - VVC menu summary
Information
/ Setting
Setting Use this to turn the system on or off.
Setting The maximum current to draw from the shore
supply.
Information Indicates the current status of the system.
Information The battery voltage.
The D.C. current flow between the battery and
the target system.
Information The voltage of the mains power supply,
Information The current being drawn from the mains
supply.
Information The power being consumed from the mains
supply.
Information The frequency of the mains supply.
Information The voltage being produced by the inverter.
Information The current drawn from the inverter.
Information The power consumed from the inverter.
Information The frequency of the inverter output.
Information The firmware version of the VVC.
Details