Victron energy VE.Net Blue BPP2 Manual De Instrucciones página 31

VE.Bus device menu
Current device
Flash LEDs
System defaults
VE.Bus sys setup
General menu
Sys. frequency
Transfer switch menu
Wide input freq.
Ground relay
AC low discon.
AC low connect
AC high discon.
AC high connect
UPS function
Dyn. Cur. lim.
Default cur lim
Inverter menu
Inverter voltage
DC low shutdown
DC low restart
Setting Selects the device to communicate with for
configuration options, and values in the
"Device specific" menu.
Setting Flash the LEDs on the device selected with
the "Current device" property.
Setting Restore all target settings to their default
values.
Setting The current configuration of the VE.Bus
system. See chapter 6.5 - VE.Bus system
configuration for more information.
Setting The frequency of the mains supply in your
region.
Setting Allows the A.C. input frequency to be
anywhere from 45 – 65 Hz.
Setting Enable this for systems with an earth leakage
circuit breaker.
Setting The voltage at which the transfer switch will
disconnect the A.C. supply, and switch to the
inverter.
Setting The voltage above the disconnect voltage at
which the transfer switch will re-connect the
A.C.
Setting See "AC low discon."
Setting See "AC low connect"
Setting Enables or disables the fast checking of the
A.C. waveform. Disabling this will result in
slower transfer speeds, but will be more
tolerant of poor input signals.
Setting When enabled, the inverter will be started if
the load increases rapidly, to avoid voltage
drops as the generator adjusts to the new
load.
Setting The value that will be used for the shore
current limit if no VVC or remote panel is
connected to the target.
Setting The desired output voltage of the inverter.
Setting The inverter will switch off when the battery
voltage drops to this level.
Setting The inverter will restart when the battery
voltage rises this far above the shutdown
voltage.
25