Bose ControlSpace WP22BU-D Guia De Instalacion página 13

pro.Bose.com
channel 1. However, the second Dante output comes from one of three
possible input mixes:
• A mono mix of the RCA jack inputs
• A mono-mix of the 3.5 mm stereo jack inputs
• A combined mix of the RCA inputs and the stereo jack inputs
The mix selection can be set using ControlSpace Designer software.
The WP22BU-D has two output options. An XLR connector provides
a balanced line output for analog output 1 only, and a 3.5 mm stereo
jack connector provides an unbalanced line level output for both analog
output 1 and analog output 2. Both output connectors may be used
simultaneously.
2
3
IN 2A
IN 2B
Figure 2. WP22BU-D internal audio block diagram
Connection to the Dante network is provided by a single Ethernet
RJ-45 connector on the back of the unit. The WP22BU-D is PoE
powered over the network cable from a suitable PoE source (IEEE
802.3af) eliminating the need for a local power supply
ControlSpace Designer software is used to configure specific features
and the audio routing of this device.
WP22BU-D Installation Guide
IN 1
1
A, B, A+B
Selected in ControlSpace
Designer Software
™
T x 1
R x 1
®
Dante
Network
T x 2 R x 2
OUT 1
1 2
3
OUT 1/2
13