Mutsy Nexo Manual De Instrucciones página 12

is located at the rear of the back support.
· Pinch the button and continue pressing
it while moving the back support back-
wards to lower the back support. Re-
lease the button when the back support
has reached the desired position.
· Pinch the button and continue pressing
it while moving the back support for-
wards to bring the back support in an
upright position. Release the button
when the back support has reached the
desired position.
Reclined carriage postition (0 – 6 months)
· Make sure the seat is in fully reclined
position and the leg rest up.
· The zip for the leg rest barrier is at the
bottom of the leg rest.
· Open the zipper and pull it from the
pocket.
· Fold back the fabric of the leg support.
· Fasten the press studs of the leg rest
barrier to the corresponding studs on
the side of the seat.
· Always use the crotch strap in the most
rearward crotch strap position in the re-
clined carriage position.
· Never use the reclined carriage position
of the seat unless the child is properly
secured with the 5-point safety harness.
· Undo the press studs in order to store
the leg rest barrier. Open the zip on the
pocket.
· First fold the two sides with the press
studs inwards and then fold in the
centre section. Put the 2 fabric parts
under the centre section when folding
and make sure that there are no sharp
corners in the ribbing.
· Close the zip on the pocket.
Adjust the leg support (n)
· Lift the leg support to place it upwards.
· Pull the tube (n1) at the bottom of the
leg rest to lower it again.
Attach and remove bumper bar (o)
· To secure the front bumper, press the
ends of the bumper into the recesses
(o1) intended for this purpose on the
frame until you hear a click.
· Press the unlock buttons (o2) on the
inside of the bumper bar to remove the
bumper bar from the frame.
Place the hood (p)
· Press the clips of the hood on the
correct location on the frame. The
hood is fixed on the tubes of the
frame. (p1)
· Subsequently, attach the fabric of
the hood to the top of the back sup-
port using the studs. (p2)
Adjust the hood (q)
· Hold the front hood bar in the centre
and move it forwards or rearwards to
adjust the hood (q1)
· Open the zipper in the centre of the
opened hood in order to enlarge it. (q2)
· Close the zipper to again reduce the
hood.
· Pull the flap on the front side of the
hood outwards to additionally enlarge
the hood. Push the flap inwards to
again reduce the hood.
Remove the hood (r)
· Release the studs at the top of the seat
(r1). Then press the lip (r2) at the bot-
tom of the clips of the hood inwards
and remove the hood.
Assemble the rain cover on the pushchair (s)
· Make sure that the hood of the push-
chair is in the upright position.
· Possibly open the zipper in the rain
cover to adapt it to the enlarged hood
of the pushchair.
· Place the rain cover from top to bot-
tom over the pushchair and make sure
English
7