The Seat; The Maxi-Cosi Car Seat; Place The Maxi-Cosi Adapters On The Frame (Y) - Mutsy Nexo Manual De Instrucciones

English
that the rain cover is attached well
behind the back support and over the
footrest.
The 5-point safety harness (u)
· Place your child in the pushchair and
make sure that the legs of your child are
placed on each side of the crotch strap.
· Make sure that the hip and shoulder
belt is positioned correctly over your
child and place both plastic clamps in
the central part of the harness attached
to the crotch strap.
· In order to adapt the length of the
shoulder belts, you release the shoulder
protection from the belt by pulling the
Velcro loose. The straps of the belt are
now free in order to adapt the length.
You adapt the length by sliding the
straps over the shoulder belts until both
shoulder belts properly harness your
child. Slide the strap down to make the
belt longer. Move the strap upwards to
make the belt shorter. This will create
a loop in the belt. Hold on to the strap
and pull the clamps to take the loop out
of the belt again.
· Attach the shoulder protection to the
belt again on both sides after adjust-
ment by pressing the velcro together
again.
· The back support contains three posi-
tions for the shoulder belts. Release both
shoulder belts by inserting the fasten-
ing rings at the rear of the back support
through the openings. Look for the fas-
tening ring through the fabric (v1). Tilt
it and push it through the opening. (v2)
· Move the attachment rings through the
desired openings so that the shoulder
belts are positioned properly.
· In order to adjust the position of the
crotch strap, open the upholstery under
the seat by pulling the velcro loose. The
fastening ring of the crotch strap is lo-
8
cated at the bottom of the seat between
the seat and the elastic. You can tilt the
fastening ring with your hand and push
it through the opening to adjust it.
· Regularly check the length and position
of the belts and adjust, where necessary.
Maxi-Cosi car seat
· The Maxi-Cosi car seat adapters are
suitable for use with the Maxi Cosi
Mico: 5-22 lbs. 19-22 in. (2,2-10 kg,
48-74 cm) and Maxi Cosi Prezi: 4-30
lbs., <29 in. (1.8-13.6 kg, <74cm).
· WARNING: When using a Maxi-Cosi
Prezi make sure the pushbar height
limiters are assembled.
· Always observe the instructions in the
manual of your Maxi-Cosi car seat be-
fore you start using the car seat.
· Make sure that the frame has fully been
unfolded and the brake blocked during
all actions indicated below.
Place the Maxi-Cosi adapters on the
frame (y)
· The adapter marked with 'R' is placed
on the right side of the frame, the
adapter marked 'L' is placed on the left
side.
· Remove the bumper bar and the hood.
· There is an opening at the front of the
adapter. Put the opening of the adapter
around the cam (y1) on the frame from
the outside.
· Turn the top of the adapter inwards (y2)
until it clicks. Check that the adapter
has been attached properly by trying to
lift it from the frame.
Place the pushbar height limiters when
using a Maxi Cosi Prezi car seat. (X)
· The pushbar height limiters ensure suf-
ficient space between the prezi carseat
and the pushbar to avoid the risk of
head entrapment.