Inhab; Installation And Assembly; Dimensions - Graf Klaro E Professional Instrucciones Para El Montaje

The installation of the tank must follow the directions in the enclosed installation instructions.
These instructions also contain further information on the installation conditions for the tanks and how to
connect up the infeed and overflow lines.
The emergency overflow should be fitted during assembly of the dividing wall, see section 3.1.
During the operation of a wastewater treatment system unpleasant odour may arise. The location of the
wastewater treatment system should not be chosen close to the living area (patio, windows on buildings,
etc.).
A ventilation as described in section 6 is absolutely necessary to avoid odour nuisance as far as possible.
Pre-
Schlamm-
treatment/
speicher/
Sludge
Puffer
storage
(AS)
Tank
Inhabitants
Total volume
Length
Width
Height
Min. Water level SBR
Max. Water level
Max. Water level
primary treatment
Height buffer storage
Height sludge storage
Inflow
Inflow *
Outflow
* alternative inflow height is possible
** with MINI telescopic dome shaft
Depending upon local conditions, the inflow can be either on the tank dome or on the tank at the front.
1.

Installation and assembly

2.
SBR
SBR-
reactor
Reaktor
L
2700 l

5 Inhab.

2700 l
L 2080 mm
W 1565 mm
2010 mm/
H
1680** mm
H 850 mm
BB,min
H 1010 mm
BB,max
for
HW 1100 mm
tot
H 350 mm
P
H 750 mm
S
515 mm/
E
205** mm
750 mm/
E*
430** mm
755 mm/
A
435** mm
info@graf.info
www.graf.info

Dimensions

3750 l
8 Inhab.
3750 l
2280 mm
1755 mm
2200 mm/
1870** mm
960 mm
1180 mm
1280 mm
430 mm
850 mm
515 mm/
205** mm
750 mm/
430** mm
755 mm/
435** mm
14 / 45
4800 l 6500 l
10 Inhab. 14 Inhab.
4800 l 6500 l
2280 mm 2390 mm
1985 mm 2190 mm
2430 mm/ 2710 mm/
2100** mm 2380** mm
1130 mm 1310 mm
1370 mm 1600 mm
1480 mm 1750 mm
480 mm 600 mm
1000 mm 1150 mm
515 mm/ 515 mm/
205** mm 205** mm
835 mm/ 855 mm/
515** mm 535** mm
840 mm/ 860 mm/
520** mm 540** mm