Insert The Batteries; Units Of Measurement - Xavax Jewel Instrucciones De Uso

G Operating instruction
Thank you for choosing a Xavax product.
Take your time and read the following instructions
and information completely. Keep these operating
instructions in a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety
instructions or to draw your attention to specific
hazards and risks.
2. Package Contents
• Fine Scales
• 2 CR2032 batteries
• These operating instructions
3. Controls and Displays
1. Unit button: Select the units of measurement
2. Switch display backlight on/off
3. Display
4. TARE button: tare function
5. Power on/off button
6. Weighing surface
4. Safety Notes
• This device is intended for private, non-
commercial use only.
• Protect the device from dirt, moisture and over-
heating, and only use it in dry locations.
• Do not drop the device and do not expose it to
any major shocks.
• Do not operate the device outside of its operating
limits as de ned in the technical speci cations.
• Do not open the device or continue to operate it
if it becomes damaged.
• Keep the packaging material out of the reach of
children due to the risk of suffocation.
• Dispose of packaging material immediately
according to locally applicable regulations.
• Do not modify the device in any way. Doing so
voids the warranty.
2
Warning - batteries
• When inserting batteries, note the correct
polarity (+ and - markings) and place.
• the batteries accordingly. Failure to do so could
result in the batteries leaking or exploding.
• Do not short-circuit the batteries.
• Do not recharge the batteries.
• Do not throw the batteries in a re.
• Keep batteries out of the reach of children.
• Do not allow children to change batteries
without supervision.
• If the device is not used for a long period of
time, remove the batteries.
5. Getting Started

5.1 Insert the batteries:

Open the battery compartment on the back and
insert two CR2032 button cell batteries. Make
sure that the polarity (+/-) is correct. The positive
pole (+) must point upwards. Close the battery
compartment fully.

5.2 Units of measurement

The following units of measurement are available:
g (gram), ct (carat), gn (grain), oz (ounce), ozt (troy
ounce) and dwt (pennyweight). Press the Unit
button to select one of the units of measurement in
the given order: g-ct-gn-oz-ozt-dwt-g.
5.3 Weighing
• Place the scales on a clean, level table. Make
sure that the scales are stable and do not tilt.
• Switch on the scales by pressing the Power on/off
button. Initially all symbols appear on the display.
Please wait until '0.0 g' appears. You can then
place the item to be weighed onto the scales and
read the weight value.