BRONDI FX-400 Twin Manual De Instruccion página 4

2.4 Charging the batteries using direct charger
a. Lift up the Mic/Ear/Charger cover, insert the round connector at the side of the unit.
b. Plug in the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket
set to OFF.
c. Switch ON the main socket.
d. It takes about 10 hours to fully recharge the batteries if they are completely run down. New
batteries take up to 14 hours to fully charge.
2.5 Charging the batteries using Desktop charger
a. Insert the small plug on the end of the mains adaptor into the Power-in Connection Jack at
the back of the desktop charger.
b. Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket
set to OFF.
c. Switch ON the main socket.
The FX-400 must be charged using the mains adaptor provided. Using any other adaptor will
result in non-compliance with EN60065 and will invalidate any approvals & warranty.
d. Place the FX-400 units in the charge cradle in an upright position and facing outward. The
Charge LED indicators will light up.
e. It takes about 10 hours to fully recharge the batteries if they are completely run down. New
batteries take up to 14 hours to fully charge.
Insert the round connector of the 9.0V DC/200mA
adaptor into the charge jack.
Plug the mains adaptor into a 230V AC, 50Hz main
socket with the switch on the socket set to OFF.
Then switch ON the main socket.
Note:
During PMR direct charging mode, the unit transmit and receive is disabled
Main socket
Important:
Always turn off the PMR units
when charging.
shorten the charging time.
.
- 4 -
This will