Adjusting The Speaker Volume; Changing Channels; Setting The Ctcss Sub-Channel - BRONDI FX-400 Twin Manual De Instruccion

3.2 Turning the Unit ON/OFF
To Turn ON;
a. Press and hold the POWER button until the LCD Screen turns ON and displays
the current channel.
To switch OFF;
b. Press and hold the POWER button until the LCD screen turns blank.
You can hear a musical tone each time to confirm.

3.3 Adjusting the Speaker volume

The volume level is shown by vertical bars the LCD screen. You can change the volume while
using your FX-400, or while the unit is idle (switched on but not in use).
press the UP button to increase, or press the DOWN button to decrease the speaker volume.

3.4 Changing Channels

The FX-400 has 8 available channels, to communicate with other FX-400 users within a range,
you must all have your FX-400 tuned in to the same channel.
a. Press the MENU button once, the current channel number flashes on the LCD
Screen.
b. Press the UP or DOWN button to select the desired channel
c. The channel changes from 1 to 8, or vice versa.
d. Press the PTT button to confirm the channel setting.
Note: Refer to the "Channel Table" section of this Owner's Manual for detailed frequency
listing.

3.4.1 Setting the CTCSS sub-channel

Each channel also has 38 sub-channels to let you set up group of users within the same
channel for more private communication. If you have set the sub-channel, you can only
communicate with other PMR users turned to the same channel and sub-channel.
a. Press the MENU button twice, the current CTCSS sub-channel number flashes on
the LCD Screen.
b. Press the UP or DOWN button to select one of the 38 CTCSS sub-channels.
c. Press the PTT button to confirm the sub-channel setting.
To turn the sub-channel function off, simply set the sub-channel to 0 (zero). You can
communicate with any FX-400 user set to the same channel who also turns off the
sub-channel operation (or whose FX-400 unit does not have the feature).
3.4.2 SETTING THE DCS ADVANCED DIGITAL CODE.
Each channel also has 83 digital codes to let you set up group of users for more secured
private communication.
a. Press the menu button 3 times. DCS code flashes on the LCD screen.
b. Press the UP or DOWN button to select the desired DCS code.
c. Press PTT button to confirm the DCS setting.
- 6 -