Setting The Dual Watch Mode; Lcd Screen Back Light - BRONDI FX-400 Twin Manual De Instruccion

3.12 Setting the Key Tone ON or OFF
This feature allows the FX-400 to emit a confirmation tone after pressing each button.
a. Press the MENU button 11 times, "ON" flashes on the LCD Screen.
b. Press the UP or DOWN button ("ON" will be displayed on the LCD screen) or
deactivate ("OFF" will be displayed on the LCD screen) the key tone feature.
c. Press the PTT button to confirm your setting.

3.13 Setting the Dual Watch Mode

Your FX-400 is capable of monitoring two channels, the current and another (dual watch)
channel. If the unit detects a signal on either channel, it will stop and receive the signal.
a. Press the MENU button 12 times, "DCM" will be displayed while "OF" flashes on
the LCD Screen.
b. Press the UP or DOWN button to select the Dual Watch channel (1-8, except the
current channel).
c. Press the MENU button to change the CTCSS code.
d. Press the UP or DOWN button to select the desired CTCSS code (1-38)
e. Press the MENU button to change the DCS code.
f. Press the PTT button to confirm your setting.
g. Press the PTT button to exit.
4. Auxiliary Features
4.1 Key Lock
The Key Lock feature allows user to disable the UP, DOWN and MENU buttons so
that the FX-400 settings could not be changed accidentally.
a. To activate the Key Lock feature, press and hold the MENU button until"
appears on the LCD Screen.
b. To deactivate the key Lock feature, press and hold the MENU button until"
disappears on the LCD Screen.
The PTT and POWER buttons will remain functional even if the Key Lock feature is
activated.

4.2 LCD Screen Back Light

Every time a button is pressed (except PTT and CALL button), the LCD Screen
back light will illuminate for 5 seconds.
4.3 Microphone/Earphone/Charge Jack
The FX-400 is equipped with an auxiliary such as Mic/earphone, and charge jack
which is located at the opposite side of the PTT button.
4.4 Shoulder Mic
The FX-400 is designed and capable to use the Shoulder Mic accessory. To
activate this kind of accessory.
a. Insert the round connector in the FX-400 Mic/Earphone/Charge jack. (Be sure
your FX-400 is turn on and have the same channel with other PMR).
b. Press and hold the PTT button on the right side while speaking. To stop
conversation release the PTT button and you are now in receive mode.
- 9 -
"
"