Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Specifications
Range
Sensing angle
Electrical load - incandescent
Power requirements
Operating modes
Bulb modes
Time delay
DualBrite timer
Pre-Installation
PLANNING INSTALLATION
Before installing the motion sensor, ensure that all parts are present (see Hardware Included on page 4). If any part
is missing or damaged, do not attempt to assemble, install, or operate this motion sensor.
Estimated installation time: 30 minutes
TOOLS REQUIRED
Phillips
screwdriver
Wire strippers/
cutters
Electrical tape
Up to 100 ft. (30 m) - Varies with surrounding temperature
Up to 270°
Up to 300 watt maximum (Up to 150 watt maximum per bulb
holder)
120 VAC, 60 Hz
Test, Auto, Manual
Security, BulbSaver, AlertFlash
1, 5, 20 minutes
Off, 3 hours, 6 hours, dusk-to-dawn
Flathead
screwdriver
Circuit tester
Silicone sealant
Safety goggles
3
Please contact 1-866-308-3976 for further assistance.
Pliers
Work gloves
Ladder
HOMEDEPOT.com
Publicidad
Capítulos
Tabla de contenido
