Using Manual Mode; Care And Cleaning - Defiant DF-5716-BK-A Guía Para El Uso Y Cuidado

Operation (continued)
Adjusting the LAMP MODE
7
Switch
The "LAMP MODE" switch determines the way the
lights will turn on when motion is detected.
Security ("NORMAL") - Light comes on instantly.
BulbSaver ("SOFT") - Light comes on dim and
gradually increases to full brightness. When the
light turns off it will gradually dim to half-bright,
pause, and then will continue dimming until the
light turns off.
AlertFlash ("FLASH") - Light flashes on then off
twice before turning on full brightness.
Set the "LAMP MODE" to "NORMAL", "SOFT",
or "FLASH" position.
LAMP MODE
NORMAL SOFT FLASH

Care and Cleaning

To prolong the original appearance, clean with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this motion sensor. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Do not spray with a hose or power washer.
8

Using Manual Mode

Manual mode overrides the motion sensor (A) and
"ON-TIME" control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (A) will reset to motion
sensing mode at sunrise. Manual mode can be toggled
on and off using a wall switch.
To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
A
Turn the switch
OFF for 3 to 4
seconds
8
Turn the
switch
back ON