Operation - Defiant DF-5716-BK-A Guía Para El Uso Y Cuidado

Operation

1
Adjusting the Motion Sensor
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from standard PAR38 bulbs.
CAUTION: Keep the motion sensor at least 2 in. (50 mm)
away from halogen bulbs.
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Loosen the lock nut (3) and screw (4) to adjust
the motion sensor (A) for the desired coverage.
Rotate the motion sensor (A) so the controls
face toward the ground.
Tighten the lock nut (3) and screw (4).
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
3
4
2
When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day
or night. The light will stay on for 5 seconds after all
motion is stopped.
MIN
A
6
Setting the Sensor for Testing
Set the "ON-TIME" switch to the "TEST"
position.
Set the "DUALBRITE" switch to the "OFF"
position.
Turn the "RANGE" dial to the "MIN" position.
Aim the motion sensor (A) in the general
direction of the area to be covered.
NOTE: The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
LAMP MODE
NORMAL SOFT FLASH
ON-TIME
MAX
TEST 1 5 20
RANGE
MINUTES
DUAL BRITE™
OFF 3 6 DUSK TO
HOUR DAWN
A