Foam Insert Removal And Replacement - Permobil ROHO Hybrid Elite Manual De Operación

Foam Insert Removal and Replacement

Foam Insert Removal:
1. Remove the cover from the cushion. See "Cover Removal".
2. Slide the tubing out of the loop on the foam insert.
Repeat for other side.
3. Flip the cushion over so that the cells face down and the bottom
of the contoured foam base faces up.
4. Pull the foam insert flap away from the hook fastener pieces on
the bottom of the contoured foam base. Repeat for the other
side.
5. Flip the cushion over so that the cells are face up and the
bottom of the contoured foam base faces down. Release the
foam insert from the contoured foam base by pulling away from
the hook fastener pieces.
Foam Insert Replacement:
Warning: The foam insert must be correctly positioned on the contoured foam base.
Note: If the cushion insert was removed from the contoured foam base, replace the cushion insert
before replacing the foam insert. See "Cushion Insert Replacment".
1. Position the foam insert on the contoured foam base.
- The foam insert is next to, but not on top of, the air
cells. (A)
- The foam insert lines up with, but does not extend
past, the front edge of the foam base. (B)
- The foam insert is centered on the foam base.
2. Once correctly positioned, press down on the foam
insert to securely attach it to the contoured foam base.
3. Slide the tubing through the loop on the foam insert. As
needed, push the tubing back into the groove. Repeat for
other side.
4. Flip the cushion over so that the cells are facing down and
the bottom of the contoured foam base is facing up.
5. Pull and attach the foam insert flaps to the hook fastener
pieces on the bottom of the contoured foam base.
6. Flip the cushion over so that the cells are facing up and the
bottom of the contoured foam base is facing down.
7. Replace the cover. See "Cover Replacement".
ROHO Hybrid Elite Cushion Operation Manual
7
A
B
Center