Operation; Control Elements - ABB Welcome 83327-500 Manual Del Usuario

ABB-Welcome
Pos : 18 /DinA4 - Anl eitungen Onli ne/Ueberschriften/1./Bedi enung @ 18\mod_1302613924165_15.doc x @ 103365 @ 1 @ 1
4

Operation

Pos : 19 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Nor maler Betrieb @ 18\mod_1302768820965_15.doc x @ 103540 @ 2 @ 1
4.1

Control elements

Pos : 20 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Bedi enel emente @ 20\mod_1323260220559_15.doc x @ 111647 @ 3 @ 1
Pos : 21 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/83220-AP- xxx/Bedi enelemente - 83220- AP- xxx @ 18\mod_1303212853605_15.doc x @ 103673 @ @ 1
Fig. 1: Overview of control buttons
No. Functions
Bus in
1
2
Bus out
CVBS out
3
Switch on camera power supply.
4
For details, please see
supply
Working mode
5
There are 4 modes for the camera interface, For details, please see
Chapter 4.3 Operation mode.
6 Set the address of the associated devices.
7 Set the address of the camera interface.
Operating status notification LED
8
-Green: ready for operation
-Orange: in setting mode
-Red: fault
Dip switch to switch on/off the video channel.
9
Program button to enter the programming mode.
10
4 video in. (supports CVBS signal input)
11
Pos : 22 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Steuermodul e - Onli ne-D okumentation (--> F ü r all e D okumente <--)/++++++++++++ Seitenumbruc h ++++++++++++ @ 9\mod_1268898668093_0.doc x @ 52149 @ @ 1
|
Chapter 4.4 With & Without permanent power
— 5 —