Maintenance; Filter; Cleaning A Dry Filter; Cleaning A Wet Filter - Workshop WS1600SS0 El Manual Del Propietario

Filter

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter.
WARNING:
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.

MAINTENANCE

Do not operate

Cleaning A Dry Filter

NOTE: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the Vac.
Simply slap your hand on top of the
handle while the Vac is turned off.
2. Remove filter from Vac. Gently tap the
filter against the inside wall of your
dust drum and the debris will loosen
and fall.
3. For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.

Cleaning A Wet Filter

After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter. Allow
filter to dry out before storing.
14