Observed Norms; Problem Solving - Skymsen LI2 Manual De Instrucciones

• Check the ON/OFF button, Reset button, electronic
circuits for signs of overheating, damaged insulation or
mechanical damage.
• Check for possible looseness in the assemblies and
bearings.
•Check the retainers, o'rings, v'rings and other seals.
Use your QR Code Reader to access
more information regarding safety and
maintenance.

8. PROBLEM SOLVING

PROBLEMS
- The equipment does not start.
- Burn smell or smoke.
- The equipment switches ON but
when the product is placed inside the
cup the knife stops or turns slowly.
- Damaged cord.
- Strange noises.
- The product does not blend.
- Cup leaking.

7. OBSERVED NORMS

ABNT NBR NM 60335-1
IEC 60335-2-14
CAUSES
- Energy Shortage.
- Problem with the electric circuit.
- Problem with the electric circuit.
- Problems with the electric motor.
- Problem during transportation.
- Damaged bearing.
- Product pieces too large.
- Blunt knife.
- Damaged sealing.
SOLUTIONS
- Check energy supply.
- Call Technical Assistance.
- Call Technical Assistance.
- Call Technical Assistance.
- Call Technical Assistance.
- Call Technical Assistance.
- Cut product pieces 3,5cm wide.
- Call Technical Assistance.
- Call Technical Assistance.
5