PRODUCT IDENTIFICATION
Top
Shell
Thermocouple
Ignitor
Electrode
Burner Tube
Piezo Ignitor Button
Valve Inlet
Hose/Regulator
Assembly
Figure 1 - Product Identification
UNPACKING
1. Remove all packing items applied to heater for shipment. Keep
plastic cover caps (attached to valve inlet and hose/regulator
assembly) for storage.
2.
Remove all items from carton.
3.
Check all items for shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
THEORY OF OPERATION
The hose/regulator assembly attaches to the
The Fuel System:
propane gas supply. This provides fuel to the heater.
The piezo ignitor lights main burner.
The Ignition System:
The Automatic Control System:
shut down if the flame goes out.
111695-01 C
Control Knob
Base
This system causes the heater to
For more information, visit www.desatech.com
For more information, visit www.desatech.com
PRODUCT IDENTIFICATION
THEORY OF OPERATION
PROPANE SUPPLY
You must provide propane gas and propane tank(s).
Use this heater only with a propane vapor withdrawal supply
system. See Chapter 5 of the Standard for Storage and Handling of
Liquefied Petroleum Gas, ANSI/NFPA 58 and/or CAN/CGA B149.2.
Your local library or fire department will have this booklet.
This heater will operate with a 20-pound (9,07 kg) propane tank.
However, you can only operate it in the LOW position during mildly
cool weather. At higher heat settings or during colder weather, you
must use larger tanks.
The amount of propane gas ready for use from propane tanks varies.
Two factors decide this amount.
1.
The amount of propane gas in tank(s)
2.
The temperature of tank(s)
The chart below shows the minimum number of 100-pound (45 kg)
tanks needed to run the heater. Connect tanks together with a
manifold.
Average Temperature (°F[°C]) Number
At Tank Location
60° (15,6°)
40° (4,4°)
32° (0°)
20° (-6.7°)
10° (-12,2°)
0° (-17,8)
Less gas is vaporized at lower temperatures. Your local propane gas
dealer will help you select the proper supply system.
VENTILATION
WARNING: Provide at least a 2.5 square foot (76
cm) opening of fresh, outside air while running heater.
If proper fresh, outside air ventilation is not provided,
carbon monoxide poisoning can occur. Provide proper
fresh, outside air ventilation before running heater.
UNPACKING
PROPANE SUPPLY
VENTILATION
Of Tanks
1
1
1
1
2
2
3 3