REFRIGERATOR INSTALLATION
NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow
opening. If it is necessary to remove the handles, follow the directions below.
REMOVING AND REPLACING HANDLES (CONTINUED)
NOTE: Handle appearance may vary from the illustrations
on this page.
Removing Freezer Drawer Handle
Loosen the set screws located on the lower side of
t
e h
a h
d n
e l
w
h t i
a
. n i
handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. Allen wrench.
Replacing Freezer Drawer Handle
Place the handle on the door by fitting the handle
footprints over the mounting fasteners and tightening
the set screws with a
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. Allen wrench.
WARNING
When assembling or disassembling the handles:
•
Grasp the handle firmly to ensure it will not drop or
cause injury.
Prevent the handle from swinging toward nearby
•
people or animals.
Insert the bracket hole of the handle into the stopper
•
bolt of the door exactly, then assemble the set screws
to fix the handle in place.
Check for any gap between the door and handle
•
after the handle is fixed in place.
l l A
n e
r w
n e
h c
a
d n
e r
m
v o
t e
in. Allen wrench.
e h
12