Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
As the A/D change overflowing, display shows this with the ding sounding.
AdC
The voltage is lower. You can use a short while and chage immediately.
-BatLo-
Recharge is end.
C End
Loadcell bad connected or A/D error
Err-0
Calibration switch placed at OFF during calibration
Err-1
No enough sample (on piece counting mode)
Err-2
Calibration weigh too small
Err-3
3. OPERATION GUIDE
3.1. PREPARATION:
Adjust the base foot, watch the level, make the pan in horitzontal.
3.2. TURN ON OR TURN OFF:
3.2.1 TURN ON
Press the
ON/→ 0 ←
key, the ding sound, it displays version No. and the battery voltage level and 9, 8, 7, ..., 1, 0, the
lighting. Now the scale is in a working state.
3.2.2 TURN OFF
Long-press OFF key.
3.2.3 AUTO-OFF:
After 10 minutes in zero, scale will auto-off.
3.2.4 LOW VOLTAGE AUTO-OFF
When the voltage lower than 5.6V, then power-off.
3.3. ZERO:
When without taring the weight display is ≤ 4% Max. capa., press the
3.4. WEIGHING:
Put weight to pan.
3.5. TARE WEIGHT:
Press the
→ T ←
key, the weight display is "0", the
the
→ 0 ←
lighting, press the
3.6. FUNCIÓN AHORRO DE ENERGÍA
Zero after 40 seconds, auto save power, shows "O".
Put a weight start weighing.
3.7. BATTERY INDICATE
Battery led:
means voltage higher than 6.3V,
3.8. CHARGE
Power supplied by a internal rechargeable lead acid battery (6V/4Ah). When it shows "-bAtLo-". Please turn off and charge immedia-
tely. The time of full charging is 12 - 14 hours.
→ 0 ←
led off,
→ T ←
key, the
→ T ←
led off.
ON/→ 0 ←
key, the display shows "0", the
the→ T ←
led lighting. Pick up the weight, the weight display is negative,
means voltage between 6V and 6.3V; and
USER'S MANUAL SS
"→ 0
←". led
→ 0 ←
led lighting.
means voltage lower than 6V.
EN
13
Publicidad
Tabla de contenido
