Malfunctions And Actions To Take - Microlife BC300 Maxi 2 in 1 Manual De Instrucciones

6. Press + 5 and – 6 simultaneously for 3 seconds to switch to
one-sided pumping. The display will show mode «1» BT. This
mode should always be selected for one-sided pumping.
7. The device will begin automatically in stimulation mode BM and
a two-minute timer BN will appear on the display. During these
two minutes, your breast nipple will be stimulated in order to
prepare it for pumping the breast milk. Use the + / – buttons 5
6 to set the desired stimulation intensity.
8. After the two minutes have passed, the timer will start to flash
on the display. Press the MODE button 4 to begin pumping the
breast milk. Use the + / – buttons to select a suction intensity
that is comfortable for you. When the milk reaches 180 ml inside
the feeding bottle, interrupt the suction.
9. If you want to switch back to the stimulation mode, press the
MODE button 4. The stimulation and the two-minute timer will
start from the beginning.
10.Press the ON/OFF button 3 to switch off the device.
Storing the breast milk
Expressed milk can be stored in the fridge or freezer for a certain
period of time.
 When storing breast milk, ensure that the device and the bottles
are disinfected before usage. Only store breast milk in disin-
fected containers.
 Store breast milk in the fridge or freezer immediately after
expressing. Do not leave breast milk out at room temperature.
 If storing breast milk in the freezer, it is recommended that you
mark the bottle with the date of expressing.
WARNING
Observe the storage periods in the following table:
Room
temperature
Recently Can be kept for
expressed 6 hours
breast milk
Defrosted Use immedi-
breast milk ately
(that had been
frozen)
BC 300 Maxi 2 in 1
Refrigerator Freezer
(approx. 3 - 5 °C) (approx. -16 °C)
Can be kept for 24 Can be kept for
hours 3 months
(Do not store in
the fridge door, as
it is not sufficiently
cool there)
10 hours Do not refreeze
Feeding with the breast milk

NOTE:
You can use the supplied bottle with the silicone teat when
feeding with the breast milk. Alternatively, you can also
express the breast milk with a NUK or Avent bottle before
feeding (corresponding NUK / Avent adapter is included in
the box).
 Prior to feeding, ensure the bottle has been disinfected before
filling it with the breast milk that has been stored.
 To defrost breast milk, store it overnight in the fridge, so as to
retain the nutrients. Once the breast milk is defrosted, it must be
used within 24 hours. Breast milk should only be defrosted in
warm water in especially urgent cases.
 If the breast milk smells unpleasant, it should be disposed of
immediately.
 Never heat up breast milk in the microwave as it may be heated
unevenly and could burn your child when they drink it.
 If heating up the breast milk, check its temperature before
feeding it to your baby.

5. Malfunctions and Actions to take

Use following table for solutions if any problem occur.
Problem Potential solutions
 Check all parts of the device are correctly
There is no suction from
the device.
 Check whether the pump attachment is
 Check that the silicone tube is correctly
No breast milk is being
pumped.
 Ensure that there is no milk remaining in
 Try to relax and then attempt it again a
Pumping the breast milk
is causing pain.
 Set the suction level to MIN.
 Consult your doctor.
 Remove the silicone cushion and re-
The breast milk is
leaking out underneath
the silicone cushion.
 Lean your upper body forwards slightly.
assembled.
correctly placed on the breast.
inserted, the device is switched on and the
suction level is not set to the minimum.
the silicone valve and obstructing the
milk flow.
few minutes later. As you use the device
more and more, you will find it easier to
pump milk.
attach it. Ensure the silicone cushion is
correctly positioned and firmly secured to
the pump attachment.
EN
7