Quick TSC Manual De Instalacion Y Uso página 9

INSTALLATION
GB
INSTALLATION OF THE TSC
The TSC complies with EMC standards (electromagnetic compatibility) but requires correct installation to avoid
compromising its performance and that of the surronding instruments.
For this reason the TSC must be positioned at a distance of at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
After choosing where to position the TSC, proceed as follows:
• Position the drilling template (provided) on the surface where the command will be installed.
• Mark the centre of each hole.
• Drill the hole for the back of the remote control with a 60 mm bit and cut along the perimeter indicated.
• Remove the template and any burrs present in the holes.
• Insert the TSC into its seat.
• Fix the TSC to the panel with four countersunk head screws (not provided).
• Position the frame on the TSC.
9
TSC MAIN SWITCH COMMAND - REV001B