Assembly; Assembling The Appliance - Magic Chef MCC3GSM-1 Manual Del Usuario

ASSEMBLY

Assembling the Appliance

1. Attach drip tray to its original front
bottom position located underneath
the spout of the chamber.
2. Apply grease to the two piston rings
and spiral using the supplied grease
from the manufacturer or purchase
commercially approved edible
grease. (See A and b in Figure 1)
3. Assemble the dispenser and pull tab
lever using the supplied parts. (See
Figure 2)
4. To remove parts, release the pin and
remove the pull tab lever, push
down the spring and plastic piston
to release then wash all parts.
CAUTION: Ensure the wide border of
the gasket faces the wall. (See Figure 3)
CAUTION: before attaching the
packing cushion, apply edible grease to
the inner part of the packing cushion.
After assembly, apply the outer area with
edible grease.
5. Attach the insulation rubber sphere
to the area shown in Figure 3, add
the packing cushion first in front
shown in Figure 4, then attach the
plastic spiral properly to the packing
cushion first then finishing with the
attachment of the chamber. (See
Figure 4)
6. Align the chamber and push it fully
into the packing cushion and fixing
latch. (See Figure 5)
Figure 1
A
Figure 2
Figure 4
Figure 5
ENG-13
b
Figure 3
packing cushion