Publicidad
Idiomas disponibles
Idiomas disponibles
7
PUSH
NUTS
Connect feed wiring to fixture through wiring via push nuts.
9
SOCKET
CAP
SCREWS
Insert #8-32 x 2-1/2" socket cap screws through internal fixture
bridges and through gasket. Use nylon locknuts to secure fixtures
together. Ensure joint is secure.
11a
FOR FSR ONLY: Drill pilot holes along fixture(s) and through bracing
at locations shown above.
4
EATON
IL519010EN
GASKETING
NYLON
BRIDGE
LOCKNUT
(JOINER)
Installation instructions
8
ALIGNMENT PINS
FOR CONTINUOUS ROWS: Repeat step 2 (and 3 for FSR) to prepare
fixture. Slide fixtures together ensuring alignment pins are in the
correct position.
10
Make appropriate wire connections between fixture housings using
provided push in connectors.
11b
One screw every 2 feet per flange is recommended.
PUSH IN CONNECTOR
Publicidad
