Packing List - Cramer 82B1000 Manual De Instrucciones

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
SPECIFICATIONS
Type
Voltage
AIR volume
Air speed
Weight (Without
Battery)
Battery Pack
Charger
Sound pressure
level
Sound power level
Vibration level
Double-insulated
construction
DESCRIPTION
See Figure 1.
1. Cruise control lever
2. Trigger
3. Cord retainer
4. Socket
5. Front tube
6. Rear tube
7. Power cord
8. Backpack battery charger
9. Charger connector
10. Backpack battery
ASSEMBLY
UNPACKING
„ Carefully remove the product and any accessories
from the box.
„ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
„ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
„ If any parts are damaged or missing, please call your
Cramer service centre for assistance.

PACKING LIST

See Figure 1.
„ BLOWER ASSEMBLY
„ FRONT BLOWER TUBE (2)
English (original instructions)
82B1000
82V DC
16.9 m³/min
240 KM/H
2.1 kg
82VH1000/
88 dB(A), k:3.0 dB(A)
102 dB(A)
<2,5m/s , k=1.5m/s
2 2
„ REAR BLOWER TUBE
„ OPERATOR'S MANUAL
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
ASSEMBLING THE BLOWER TUBE
See Figure 2.
Do not connect to power supply until assembly is
complete. Failure to comply could result in
accidental starting and possible serious personal injury.
„ Connect the rear tube (5) to the front tube (6). Twist
clockwise until the tubes lock into position.
„ Align either of the grooves (11) in the tube with the
tabs (12) on the blower housing. Push the tube into
the blower housing until the tab engages the grooves.
„ Turn the tube in the direction of the arrow until both of
the tabs slide into the lock positions.
CONNECTING THE POWER CORD TO THE BLOWER
See Figure 3.
„ Secure the power cord to the motor housing using the
cord retainer. This prevents accidental removal of the
electrical cord.
„ Insert the power cord plug (A) in the socket (4) on the
back of the blower.
„ Push the plug into the socket and turn
counterclockwise until the plug's latch is engaged and
secure.
CONNECTING THE POWER CORD TO THE BACK-
PACK BATTERY. See Figure 4-5.
„ Insert the plug (B) in the socket (C) – line up the lugs
on the plug with the slots in the socket.
„ Once the end of the plug is inserted in to the socket,
turn the plug clockwise until the latch is engaged and
secure.
„ Fit cable in the cable (D) duct and wind through the
(E) housing – see also "Positioning the Cable".
POSITIONING THE CABLE See Figure 6.
The cable can be fitted in different cable ducts. If the
power tool is being used with the battery, follow the
instructions below:
„ If using next to or behind your body, fit the cable (F)
in the lateral cable ducts (G) or (H) depending on the
tool that you are using and secure into place.
1
WARNING
WARNING