Omega Lift Equipment 47050C Instrucciones De Funcionamiento Y Manual De Piezas página 5

OPERATION
Vehicle Preparation
1. Locate vehicle'd) on a hard, level surface, such as reinforced concrete, large enough to accommodate vehicle,
jacks, jack stands, and wheel dolly.
2. Set the emergency brake unless the rear drum, tire and wheel are all to be removed as an assembly.
3. Chock all unlifted tires in both directions AND take every precaution necessary to ensure the set up is stable and
will prevent all inadvertent vehicle movement.
Raising The Lifting Arms
1. Close release valve by turning it with slotted portion of handle clockwise until firm resistance is felt to further thread
engagement.
!
WARNING: Follow the vehicle manufacturers recommended removal and installation procedures for tire,
wheel, hub, or axle assemblies as needed! DO NOT remove more than is recommended by the vehicle
manufacturer!
2. After the tire, wheel assembly has been loosened from the hub or axle and is ready to be removed, position the
dolly under the assembly to be removed. Pump until load reaches desired height. Adjust lift arm tilt such that the
tire, wheel assembly will nest securely between the lift arms without falling forward (toward the front wheels).
Loading the Wheel Dolly
!
WARNING: NEVER load this device with more than the weight of the wheel assembly to be removed!
ENSURE that the vehicle is securely positioned and supported by mechanical means such as a pair of
appropriately rated jack stands or cribbing and blocking.
!
WARNING: NEVER use a wheel dolly as a wheel pulling device. Before transporting wheel assembly.
Ensure that it is free from the hub or drum assembly and that it is secured to the wheel dolly using the
provided restraint device.
When the weight of the loosened tire, wheel assembly is supported by the wheel dolly, Carefully roll the wheel dolly
away from the drum or axle. When the assembly is clear, immediately secure the tire/wheel assembly with the
provided chains.
Lowering
Engage and slowly turn the release valve counterclockwise, but never more than 1 full turn.
!
To avoid crushing and related injuries and or property damage:
• Read, understand and follow all printed materials provided with and on this wheel
dolly
• Do Not exceed rated capacity.
• Before positioning wheel dolly, ensure that the vehicle is securely positioned and
supported by mechanical means such as a pair of appropriately rated jack stands or
cribbing and blocking.
• Use only on smooth, hard and level surfaces capable of sustaining the load.
• Chock each unlifted wheel assembly in both directions.
• Be alert and sober when using this product! Never operate this equipment when
under the influence of drugs or alcohol.
• Before moving, lower the load to the lowest possible point and assure that the load is
centered and secured with a load restraint device.
• Only attachments and/or adapters supplied by the manufacturer shall be used.
• No alterations shall be made to this product.
• Never use hydraulic unit (jack) as a stand alone device.
• Apply load as close to the vertical position of the lifting member as possible.
WARNING
5