Tecfrigo MURALE 4 -6 M Instalación Y Uso página 6

Operator's guide:
1)Unpacking instructions
2)Opening the protective cover
3)Cleaning the internal basin
I
4)Cleaning the cover and external parts
5)Holders for containers and pastry shelves
UK
6)Support shelves
7)Connection to the mains
D
8)Controls
9)Checking correct operation
E
! WARNINGS
F
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
NL
1. Adults should operate this appliance only. Do not allow children to use the controls or play with it. 2
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
P installation of the appliance should be carried out by a qualified electrician or other competent person.
4 . Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
S
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. 6
7 . The manufacturers of this appliance accept no responsibility for the consequences of misuse in
DK
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice.8
FIN
sources of heat, such as radiators, stoves, etc.
least 30 cm.
B
12 . If damp air or products to be refrigerated should cause ice to form on the evaporator, we recommend
stopping the compressor and placing the goods in special refrigerated containers, kept at the same
GR
temperature, until defrosting is completed;if this is not carried out the compressor will continue to operate
leading to a wasteful consumption of electricity and poor performance.
and unused, it is indispensable to keep the door open at least 10 cm.
CZ
EE
1. UNPACKING INSTRUCTIONS
LV
CARDBOARD BOXES 1a.
WOODEN CRATE 1b.
LT
between the appliance and pallet or crate.
the appliance on a flat, level surface.
H
it. . Sort out the packaging materials in order to facilitate disposal. . The appliance can be locked in 7
place by engaging the wheel brakes (see fig. 1).
M
2. OPENING THE PROTECTIVE COVER
1. Plug the machine into the power supply socket, as described in Chapter 7.
PL
electric lifting system
SK
3. CLEANING THE INTERNAL BASIN
1 . Remove the protection film from the stainless steel parts. . Clean the basin with a soft sponge and
SLO
neutral detergents. . Remove the plug on the rear side of the machine to drain any residual water.
4. CLEANING THE COVER AND EXTERNAL PARTS
1. Never use detergents containing alcohol or solvents which would irremediably damage the cover,
compromising its transparency. . Use only a soft damp sponge. . As far as the wooden surfaces are
concerned, use proprietary detergents especially designed for wooden surfaces, which are water-based
and do not contain solvents. . Dry with a clean cloth.
5. HOLDERS FOR CONTAINERS AND PASTRY SHELVES
1 . Remove the protection film from the holders. . Place the longer holders in the slots provided on the
basin's rims. . Place the shorter holders in the slots provided in the longer holders. Different
arrangements are available for different container sizes and positions.
on the holders
(containers and stainless steel shelves are available upon demand) (see fig. 3).
6. SUPPORT SHELVES
Take hold of the bottom edge of the shelf and turn upwards
the edge near to the basin
5
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance near
11 .Ensure that the products displayed on the shelves and grills do not hang over the edges.
Cut surrounding tape. Remove the cardboard package by sliding it upwards.
Remove the nails from the wooden crate with care. . Insert forks of forklift truck
6.
(A) to position II until the cover is fully (see fig. 2).
3
2
4
3
. 5. For pastry models, you need only place the stainless steel shelves on the rims
(B) until the shelf is firmly secured in place (see fig. 4).
Operator's guide
10)Internal and evaporator cleaning
Maintenance manual (Page 48):
1)Cleaning the condenser
2)Replacement of the lamp
3)Replacing the cover lifter motor
4)Replacing the mirror
5)Wiring diagram diagram of refrigeration unit
10 . Keep the ventilation grills free from obstruction for at
3. Lift the appliance. 4.
Make sure there is nothing left in the package before disposing of
2
3
2
(A) until the shelf is horizontal. Push down
6
3
9
13 . If the appliance is not working
2
Remove the pallet or crate. . Place
8
2 . Turn the switch of the
4. You can now put your containers
. It
5