Electrical Safety - Black and Decker Dustbuster FV7001 Manual Del Usario

Make sure that the appliance is switched off
before connecting to or disconnecting from
the power supply.
Always take care when using the appliance.
Never pull the power supply cord to
disconnect the plug from the socket.
Keep the power supply cord away from heat,
oil and sharp edges.
Do not use the appliance outdoors.
If the power supply cord is damaged during
use, disconnect the appliance from the power
supply immediately. Do not touch the power
supply cord before disconnecting from the
power supply.
Disconnect the appliance from the power
supply when not in use, before fitting or
removing parts and before cleaning.
Safety of others
Do not allow children or any person unfamiliar
with these instructions to use the appliance.
Do not allow children or animals to come near
the work area or to touch the appliance or
power supply cord. Close supervision is
necessary when the appliance is used near
children.
After use
Switch off and remove the plug from the
socket before leaving the appliance
unattended and before changing, cleaning or
inspecting any parts of the appliance.
When not in use, the appliance should be
stored in a dry place. Children should not have
access to stored appliances.
Inspection and repairs
Before use, check the appliance for damaged
or defective parts. Check for breakage of parts,
damage to switches and any other conditions
that may affect its operation.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective parts repaired
or replaced by an authorised repair agent.
Before use, check the power supply cord for
signs of damage, ageing and wear.
Do not use the appliance if the power supply
cord or mains plug is damaged or defective.
If the power supply cord or mains plug is
damaged or defective it must be repaired by
an authorised repair agent in order to avoid a
hazard. Do not cut the power supply cord and
do not attempt to repair it yourself.
Never attempt to remove or replace any parts
other than those specified in this manual.

ELECTRICAL SAFETY

Before use, check that the mains voltage
corresponds to the voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335;
therefore no earth wire is required.
ASSEMBLY
Before assembly, make sure that the
appliance is switched off and unplugged.
Assembling the long handle (fig. B)
Place the upper part (10) of the handle onto
the lower part (11) as shown.
Insert the two screws (12) into the mounting
holes (13).
Tighten the screws.
Fitting and removing the long handle (fig. C)
You can use the appliance either with the long
handle as an upright cleaner or without the long
handle as a hand held cleaner. The upright cleaner
is ideal for cleaning larger floor surfaces, whereas
the hand held cleaner is for use on smaller floor
surfaces, on upholstery and in confined spaces.
When using the appliance as a hand held cleaner,
you can also use the accessories (see below).
Fitting
Place the motor unit (15) on the floor.
Hold the handle (14) vertically above the
mounting slots (16) as shown.
Press the handle into the slots until it clicks into
place.
E N G L I S H
7