Software - PCE CT 65 Manual De Instrucciones

5.4

Software

The delivered software is kept very simple but delivers extensive information on the
measurement results at the same time. It only needs to be installed on your computer and be
started afterwards. The PCE-CT 65 can then be connected to the computer using the USB
cable. After this, the instrument needs to be started. If the device is recognized by the computer,
the software shows the following message in the top left corner:
When the instrument is connected, you can choose which working group(s) should be chosen:
When the data has been read out, there will be a dialogue window and the software will display
"Read successful!" and the values will be shown in the table.
The different working modes can be selected in the area "Data filtering". In the table, there are
the single measurements ("No."), the corresponding working group ("Group") and which material
has been measured with what thickness ("Data").
The statistics can be found on the right-hand side. Here, you can find the maximum, minimum
and the average value for that working group. The statistics are also divided into ferrous and
non-ferrous material. For the two material classes, you can also find the maximum, minimum
and average value there. In addition, the software also displays how many measurements have
been made on ferrous materials on the one hand and also on non-ferrous materials on the other
hand.
Please note that the measurement device needs to be switched on during the analysis. If it
should automatically switch off, it will also be disconnected from the computer and further
analysis will not be possible. If you want to avoid this, it is recommended that the automatic
power off-function is disabled in the settings.
© PCE Instruments