Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble Shooting Push and Turn Electronic Ignition
No sparks appear
at
any electrodes
when
burner control
knobs
are turned to
SHi;
no noise can be
heard from the
electronic
igniter
module
No sparks appear
at
any electrodes
when
burner control
knobs
are turned to
SHi;
noise can be heard
coming
from the
electronic
igniter
module
Sparks are present at
some but not all
electrodes;
spark is
weak
•
Battery
not installed properly
•
Dead battery
•
Battery
cap not installed
properly
•
Faulty ignition
module
Output
wires
are
not
connected
Electrode tip not in proper
location
•
Weak
battery
•
Some output
wires are not
connected
Arcing to grill away from
burners
•
Electrodes are wet
•
Electrodes are dirty
•
Electrodes are cracked
or
broken
•
Make sure "+"
end is facing
out.
•
Replace with new alkaline
battery.
•
Check to make sure battery
cap is fully engaged
with
battery
and screwed
onto ignition
module squarely.
•
Replace electronic
igniter
module.
•
Remove all output wires at electronic
ignition
module
and electrodes
and reconnect.
Ensure connections
are
tight.
Main Burners:
•
Tip of electrode
should be pointing
toward
gas port
opening
on burner. The distance
should be 1/8" to 3/16".
Adjust if necessary.
Rotisserie
Burner/Side
Burner:
•
Tip of electrode
should be pointing
toward
ceramic
top
on burner. The distance
should be 1/8"
to 3/16".
Adjust if
necessary.
•
Replace with new alkaline
battery.
•
Remove output wires at electronic
ignition
module
and
electrodes
that are not sparking
and reconnect.
Ensure
connections
are tight.
•
If possible, observe
grill in dark location.
Operate
ignition
system and look for arcing between
output wires
and grill frame.
Replace wires if arcing seen.
•
Use paper towel to remove moisture.
•
Clean electrodes
with rubbing
alcohol
•
Replace electrodes
28
Publicidad
