Sharp SJ-WX830F Manual Del Usario página 21

Water dispenser
Cleaning the dispenser tank
Remove the dispenser tank approximately once a month
and wash it with water.
1
Empty the dispenser tank.
Push the lever and let out all water in the dispenser tank.
2
Remove the dispenser tank from the door.
 Take the both latches off.
 Lift the dispenser tank up to remove.
1
Dispenser tank
2
3
Disassemble the dispenser tank.
 Remove the cap.
 Remove the cover. (Latches : 5 pieces)
Remove the tank pipe and the tank nozzle.

 Disassemble the tank nozzle.
2 2
2 2
1
4
Latch
1
2 2
Cover
2
Cap
2
Latch
Packing
Tank pipe
3
Tank nozzle
3
After cleaning
1
Assemble the dispenser tank.
(Reverse procedure to disassemble.)
Ensure that each parts are attached firmly. Otherwise
it may cause water leakage.
Assemble the tank nozzle.
1 2
2
Install the dispenser tank.
Insert the dispenser tank fully and make sure to fasten
the latches to install.
The dispenser tank must be installed to use.
Otherwise dew condensation may form on the inside
of the refrigerator.
Dispenser tank
3
3
2
1
2
3
Note
• When humidity is high, dew condensation may occur on
tank pipe and tank nozzle.
• Make sure not to lose the packing when you
disassemble the tank.
3
2
Hook of the dispenser
tank
Put the hook on
the protrusion of
the door.
Protrusions of
the door
Latch
Tilt the latch
back.
EN-19
EN