Install The Ups; Rack-Mount Installation; Setup The Ups - Power Walker 1000RM LCD Manual De Instrucciones

2.2. Install the UPS

For safety consideration, the UPS is shipped out from factory without connecting battery wires.
Before install the UPS, please follow below steps to re-connect battery wires first.
Step 1
EN
Remove front panel.
This UPS can be mounted in the 19" rack chassis. Please follow below steps to position this
UPS.

Rack-mount Installation

Step 1

2.3. Setup the UPS

Step 1: UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension
cords.
Step 2: UPS output connection

For socket-type outputs, there two kinds of outputs: programmable outlets and general
outlets. Please connect non-critical devices to the programmable outlets and critical
devices to the general outlets. During power failure, you may extend the backup time to
critical devices by setting shorter backup time for non-critical devices.

For terminal-type input or outputs, please follow below steps for the wiring configuration:
a) Remove the small cover of the terminal block
b) Suggest using AWG14 or 2.1mm
3.3mm
c) Upon completion of the wiring configuration, please check whether the wires are
securely affixed.
d) Put the small cover back to the rear panel.
Step 2
Connect the AC input and
re-connect battery wires.
2 2
-5.3mm power cords for NEMA type.
Step 3
Put the front panel back to the
unit.
Step 2
2
power cords. Suggest using AWG12-10 or
5