Falcon K Instrucciones De Instalación página 2

3
Install Latch.
3a Mark faceplate position.
3b Chisel 11/64" (4.3mm) Deep.
3c Install latch.
4
Install Strike.
4a Drill and prep jamb latch hole.
1" (25.4 mm)
4b Trace and prep strike plate for installation.
4c
5
L Skip this step if you purchased a standard product.
5a
5b
5c
1" (25.4 mm)
5/16" (8 mm)
5/16" (8 mm)
1" (25.4 mm)
1/8" (3 mm)
Install strike.
Install Interchangeable Core.
For 6-pin core: Insert the spacer spring (Part #5)
around the 2 prongs of the tailpiece (Part #2), and then
insert the tailpiece into the cylinder (Part #1).
For 7-pin core: Insert the tailpiece (Part #2) into the
adapting holes in the rear of the cylinder (spacer
spring is not required).
Insert the control key (Part #4) into the cylinder (Part
#1) and push the core into the opening of the lever.
Turn the control key (Part #4) around 10 degrees
counterclockwise to engage the core with the lever.
1 Cylinder
2 Tailpiece
3 Exterior Lever
4 Control Key
5 Spacer Springs
5
1
3
2
10 °
4
A-1
4
1
5
2
1
2
A-2