GF ER 52 Manual De Instrucciones página 30

Installation
5. Pull upper cam 5 off.
6. Loosen threaded bolt 4.
7. Pull the base with spindle 6 out of the housing 7.
8. Type ER 52:
- Complete spindle with respective connecting piece
- Turn brass by 180°.
9. Screw the base 6 with a wrench in the actuator.
10. Screw the spindle 7 with an Allen key into the spindle nut of the actuator (Attention: left
thread).
11. Place housing on base 6:
- Make sure that the electrical connection is in the desired position.
Secure threaded bolt 4.
-
12. Put upper cam 5 on the spindle 7.
13. Do electrical connections according to chapter 7 „Electrical Connections".
28
Instruction Manual