DeWalt D26420 Manual Del Usuario página 29

WARNING: Do not use a dustbag or
vacuum extractor without proper spark
protection when sanding metal.
1. Fit the dustbag (8) into the frame (7) as shown.
2. Attach the frame (7) to the dust extraction
outlet (14).
3. Turn the assembly clockwise to lock it in position.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure all materials to be sanded
are well secured.
• Apply only a gentle pressure to the
workpiece. Excessive pressure does
not improve the sanding effect, but
only results in an increased load on
the machine and causes the abrasive
to tear.
• Avoid overloading.
WARNING: Do not sand magnesium!
Proper Hand Position (fi g. F)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (4), with the other hand on the main handle
(18).
Switching On and Off (fi g. A)
• Switching on: press the on/off switch (1).
• For continuous operation, also press the lock-
on button (2).
• Switching off: press the on/off switch again.
Sanding (fi g. A)
• Start with the coarsest grit size.
• As the tool produces small scratch marks in all
directions, it is not necessary to sand with the
grain.
• Check your work at short intervals.
• Always switch off the tool when work is finished
and before unplugging.
Replacing the Dustbag (fi g. E)
For efficient dust extraction replace the dustbag
when it is about one third full.
1 . Carefully pull the dustbag opening (15) off the
frame outlet (16) and remove the dustbag (8).
2. Fit a new dustbag following the instructions as
described above.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
• After the tool is used in metal sanding
applications without dustbag, clean the tool
using low-pressure air.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
EN GL IS H
27