Makita XCV11 Manual De Instrucciones página 7

Indicating the remaining battery
capacity
1 1
2
► 1. Battery indicator 2. Check button
Press the check button to indicate the remaining battery
capacities. The remaining battery capacity is shown as
the following table.
Battery indicator status
On
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
slide switch actuates properly and returns to the
"OFF" position when the rear of the slide switch
is depressed.
According to your work need, you can choose two types
of the suction power; normal "1" or high "2".
Remaining battery
capacity
Off
50% to 100%
20% to 50%
0% to 20%
To start the cleaner, set the switch lever to "1" or "2" side.
To turn off the cleaner, set the switch lever to "O" side.
► 1. Switch lever
Auto-suction stop during wet
suction operation
WARNING:
Do not use for a long time while
the float is at work. Using the cleaner with its float
at work for a long time can cause overheat, resulting
in the cleaner deformation. In the worst case, it may
lead to smoke emission or fire.
WARNING:
Do not pick up foam or soapy
liquid. Picking up foam or soapy liquid can cause
foam to come out of air exit before the float works.
Continuing to using in this condition may cause an
electric shock and breakage of the cleaner.
The cleaner has a float mechanism that prevents water from
immersing into the motor when picking up more than a certain
amount of water. When the tank is full and the cleaner no lon-
ger picks up water, switch off the cleaner and empty the tank.
Carriage handle
When carrying the cleaner, carry it by holding the han-
dle on the head. The handle is retractable at the head
when not in use.
NOTE: When water is in the tank, switch off the
cleaner and empty the tank before carrying. The
water inside may leak.
7 ENGLISH
1