Description Of The Operator; Envisaged Use And Field Of Application; General Features; Dimensions - Aprimatic RAIDER 2500 Instrucciones Para La Instalacíon Mecánica, El Uso Y El Mantenimiento

OPERATOR FOR SWING GATES
1.

DESCRIPTION OF THE OPERATOR

1.1

Envisaged use and Field of application

The RAIDER 2500 electro-mechanical operator is designed to move double wing gates or single wing gates
automatically.
It should be used on residential gates only and is designed for gates which are not open/closed more than 50 times
daily.
All other uses are considered improper and therefore hazardous.
All other uses are forbidden by Aprimatic.
Caution
The operator does not form part of the support or safety system of the gate. The gate should
already have adequate safety and support features.
Only use the product for the permitted uses specifi ed. Do not use the product for purposes other than those specifi ed.
Do not tamper with or modify the product.
The product must only be installed using APRIMATIC accessories.
1.2

General features

- RAIDER 2500 operator is non-reversible and will therefore keep gates with wings up to 1.8 metres long in the open or
closed position without the need for an electric locking device.
Note: For longer wings (up to a maximum of 3 metres) you should use an electric locking device.
WARNING: The motor is non-reversing. This feature prevents intrusion on any size gate.
- The emergency release will enable manual control of the gate in the event of a power failure.
The emergency release is easily accessible on the lower part of the operator. It is guaranteed to work and is easy to use
(see par. 5.1).
- Anti-crushing safety is set by adjusting the
Information
Do NOT use other electronic units - Aprimatic S.p.A. declines
all responsibility for failure to follow these instructions.
1.3

DIMENSIONS

(see Fig.1)
1.4

Technical data

(see the Table)
IMPORTANT The noise level of the operator on release
from the wing and the pillar, is within the maximum limits
established by EU regulations.
Fig. 1
Aprimatic controller model RSK24 or any similar Aprimatic controller model fi tted.
916
856
841
363
RAIDER 2500
Technical data
Power supply
Motor supply voltage
Frequency
Power absorption
MAX thrust force
MAXstroke
MAX linear speed
Operating temperature
400
- 14 -
230 VAC
(+6 % ; -10 %)
24 VDC
50/60 Hz
100 W
2500 N
400 mm
16 mm/sec.
-20°C +65°C
140