Preparation Of The Rear Mounting; Making A Niche On The Masonry Pillar For Rear Mounting - Aprimatic RAIDER 2500 Instrucciones Para La Instalacíon Mecánica, El Uso Y El Mantenimiento

OPERATOR FOR SWING GATES
2.4

Preparation of the rear mounting

Estimate B measurement for securing the operator to
the installation (Fig.6 and Tab.1).
With this B value, calculate the length (L) for the rear
mounting as follows: L = B-Y. Assemble the two plates that
comprise the mounting to reach the length calculated (see
example in Fig.7).
The possible mounting assemblies are shown in
one is noted with its corresponding length.
Secure the plates with the screw and nut pairs
supplied.
Next, use a hacksaw to cut the operator securing plate
just behind the hole used.
Fig.8
x
do not use
this hole
Y
2.5

Making a niche on the masonry pillar for rear mounting

It may be necessary to make a niche in the masonry pillar for the rear mounting of the operator. Use
estimate the niche size.
Fig.9
Fig.8 and each
Important - In order to calculate the most suitable length of
x
the mounting (L) for your installation, you should decide on
the assembly position of the two plates (always use the
hole + one of the 5 arranged in an arc) and choose the hole
for securing the operator from one the 2
50
RAIDER 2500
Fig.7
L
2 self locking nuts M8
UNI 7473-6S ZN-B
(included in the kit)
Y holes provided.
A
MAX. from the hinge axis
Y
to the plate surface
50
150 min.
A
Y
150
- 18 -
2 screws 8x25 UNI5739-8.8
ZN-B screws (included in
the kit)
x
Fig.9 as a guide to